Archive | FAQ’S RSS feed for this section
Aside

Changing the Collet in the Turbo 300 Turbine

How to Change the Collet (or Chuck) in the Turbo 300 High Speed Handpiece It most likely will not happen for many years, but eventually the collet (also called the CHUCK)  in the Turbo 300 handpiece will wear out.  You’ll know when it’s time to replace it because the burs will slide into the collet […]

Read full story Comments { 0 }
Aside

Which High Speed Handpiece is the Best

Which High Speed Handpiece is the Best is a question we get asked often. The way this question should be asked is, “Which High Speed Handpiece is the Best for Me?” The answer depends on your circumstances and the materials you will be engraving or carving on. We held a question/answer conference call earlier today […]

Read full story Comments { 0 }
Aside

The Nature of “The Sandblasting” Beast

Sandblasting Can be Very Profitable and a Pain in the Rear End  – ALL AT THE SAME TIME. When things go right: You can produce multiples of the same item, over and over, in very little time. Beautiful glass items including wedding items, wine glasses, beer mugs, glass Christmas ornaments, crystal awards and much more. You […]

Read full story Comments { 0 }
Aside

Micro Sandblasting Improvements

The ParaBlaster Gets Some Added Features We have added some nice features to The ParaBlaster Micro Sandblasting System. It is now easier than ever to sandblast items such as glass, metal, crystal, stone, tile, rocks, christmas ornaments, wedding items and more. No Artistic Ability Required – Simply expose your pattern, place the resist film onto […]

Read full story Comments { 4 }
Aside

Dust Collection – Safety While Engraving and Carving

Dust Collection – Safety While Engraving and Carving Safety is always a big concern when it comes to wood carving and engraving. There are two things you must have to keep your work area safe and YOU safe from Dust and debris – the “dirty” part of being an engraver or carver. These two things […]

Read full story Comments { 4 }