Archive | FAQ’S RSS feed for this section
Aside

Shofu Lab Air Z Collet Replacement Process

How to Replace the Collet in the Shofu Lab Air Z (Oil Free) High Speed Handpiece The collet or chuck is the part inside the shaft of the turbine that holds onto the bur itself.  It is made to take the abuse of the bit sliding in and out. However, due to the bur sliding […]

Read full story Comments are closed
Aside

Turbine Replacement Process – NSK Presto

How to Replace the Turbine Cartridge in the NSK Presto High Speed Handpiece The NSK Presto High Speed Engraving Tool comes with a 90 day limited warranty on the handpiece and the turbine cartridge. With proper use, it will last much longer that that and provide years of vibration free, (and very quiet), operation. However, […]

Read full story Comments { 0 }
Aside

Collet Replacement Process – NSK Presto

How to Replace the Collet in your NSK Presto – High Speed Engraving Handpiece The Chuck or Collet is the part of your turbine that “holds” onto the bits – keeping them snug in your handpiece while you carve or engrave. .The collet is a wearable part of all high speed handpieces that simply wears […]

Read full story Comments { 2 }
Aside

On/Off Air Switch for Tank Compressors

On/Off Air Switch – Two Way Valve (Recommended for Tank Type Compressors) The on/off air switch is useful for turning your air pressure on or off, without having to adjust your regulator pressure or turning your compressor on or off. This Two Way Valve installs in between your regulator (or lubricator) and your high speed […]

Read full story Comments { 0 }
Aside

When Sandblasting Isn’t a Blast

When Sandblasting Isn’t a Blast Sandblasting can be very fun, satisfying and profitable….when it works right. But when it’s not working right, sandblasting can be very frustrating. The video below addresses some of the common problems associated with Micro Sandblasting and The ParaBlaster.

Read full story Comments { 0 }