Archive | FAQ’S RSS feed for this section
Aside

Blow Out! The Silicone Carbide Crunch

Micro Sandblasting Blowout! Picture this…..(some of you have lived it – no imagination needed!) You right are in the middle of an important  Glass Sandblasting Project when the bomb goes off. What in the world just happened? What’s that CRUNCHING in my teeth? (Taste’s Like Chicken – NOT!)

Read full story Comments { 1 }
Aside

Fittings – “It’s Just Not Fitting!”

Making Some Sense of All the Different Fittings How do we make some sort of sense from all the different fittings? There are so many, and so many different terms of what is what. What is a Push To Connect? What is a Quick Connect? What is a Coupler? What is a brass nipple (no, […]

Read full story Comments { 2 }
Aside

Thomas Compressor – Set up and Features

Thomas Compressor – Set up and Features Profitable Hobbies – Thomas Compressor is a commercial grade, portable compressor specifically designed for those needing to transport their compressor to trade shows or other public events. It is quiet enough to run right under the table, yet powerful enough to deliver enough air pressure for you toughest […]

Read full story Comments { 4 }
Aside

Filter – Regulator – Lubricator Set Up

Filter – Regulator – Lubricator Set Up and Why You Should Use One A filter – regulator – lubricator unit (abbreviated FRL) is an important part of your high speed engraving system. It performs three important functions: 1. Filter the air before it is delivered downstream to your handpiece. 2. Regulate the air pressure before […]

Read full story Comments { 2 }
Aside

Desiccant Filter – Why and How

Why you should use a Desiccant Filter with your Engraving System and Sandblasting System. A desiccant filter is a great way from preventing moisture from reaching your engraving equipment or contaminating your sandblasting system. When air is compressed, moisture and heat are created. When moisture is exposed to heat, it turns to vapor. Vapor can […]

Read full story Comments { 2 }