You are here: Home > FAQ'S > Turbine Maintenance > Turbo 300
Archive | Turbo 300 RSS feed for this section
Aside

Changing the Collet in the Turbo 300 Turbine

By on February 8, 2011 in Turbo 300

How to Change the Collet (or Chuck) in the Turbo 300 High Speed Handpiece It most likely will not happen for many years, but eventually the collet (also called the CHUCK)  in the Turbo 300 handpiece will wear out.  You’ll know when it’s time to replace it because the burs will slide into the collet [...]

Read full story • Comments { 0 }
Aside

Turbine Cleaning – Maintenance

By on February 23, 2010 in Turbo 300

How to Clean your High Speed Turbine using Oil Flushing Technique Flushing your high speed engraving turbine with oil is a good way to clean it out without removing the turbine from the handpiece. Proper maintenance of your high speed engraving turbine (yes – cleaning) will keep it in top shape for many years of [...]

Read full story • Comments { 1 }